Eurosec installation manual

It should be noted that if the Tamper reset has been programmed for Engineer Reset the display will show Service Due Also check all connections for trapped insulation. Display shows zone fault and panel will Remove zone wires from the problem zone at not set after the exit time has expired.

If detector tampers have been wired in parallel they will all have to be removed before the tamper would trigger. Print page 1 Print document 24 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Press NO, the display will show: If this option has been invoked by your installation fpx the Set or Unset Status will only be displayed for ten seconds when the system is Set or Unset.

Follow the normal instructions to the end for programming codes. The CPX is capable of using two methods to activate the Duress signal. Setting or Unsetting the system using the code that is programmed as User 7 will activate a Duress signal. The term Open relates to the system being Unset. Please refer to the Using G-Tag section for instructions. User number 1 will always be a Master Level User but the remaining 14 User Codes may be programmed by a Master Code to the required level of access.

Before attempting to reset your system ensure that the system is Un-set. This section to completed by the installation engineer Page 2 Furosec A fault sounder will start, enter a valid User Code to stop the fault sounder. A Master level code may change the status of the Chime between On and Off. This Site ID will identify what system is calling you.

To initiate the Remote Call follow the instructions below. Your installation company will have determined what size battery is required to comply with legislation. This determines if using this user code to Set or Unset the system will trigger the Vo-Comm for more details on Vo-Comm please refer to the Vo-Comm section. If you let me know your order number we can send you an engineering manual for the panel. The display will clear once the power is restored.

Page 13 Enter your User Code again followed by. Note: Pressing the Quick key during exit will shorten the exit time to 3 seconds. Enter your User code Then press Reset. The display is now reset. These are. User Numbers 1 to 3 Master Level.

User Numbers 4 to 7 User Level. Allows Set, Part Set and Unset. User Numbers 8 to 9 Set Only Level. Page 16 Press No. Do You Want to. The display will show:- Program Codes? Press Yes. Select 1. The display will show for example:- Code Page 17 Text is entered in a similar way that you would enter text on a mobile telephone. Select characters from the list below:- YZ blank Enter the required character followed by Yes.

Continue until you have entered eight characters. To use these options please follow instructions below. Delete Zone Option This option allows individual zones to be deleted omitted when the system is being set.

Note: Zone delete is only effective for one Set and will need to be repeated for subsequent Sets. Page System Test Press 0 twice. The display will show for example:- Set User 1? As each device is operated there will a tone from the internal sounders and the display will show the triggered circuit.

To test the bells external sounders and strobe press 9. To stop the bell test press 9 again. To escape back to Unset press 0 three times. The display will show:- Test? Press No.